Safety Syringe Barrel Mold (1ml, 2ml, 2.5ml, 3ml, 5ml,10ml, 20ml)

Specification of Safety Syringe Barrel  Mold (1ml, 2ml, 2.5ml, 3ml, 5ml,10ml, 20ml)

The Current Safety Syringes Mainly Have the Following Design Schemes:

• After the nurse finished using it, the needle was pulled into the syringe, and the syringe push rod was broken or stuck inside the syringe.

  
  

• Set a sleeve outside the syringe, and after use, the entire syringe includes the needle retracted into the sleeve to prevent needle injury. At the same time, all accessories of the syringe are locked or jammed, achieving the function of a medical safety self destructible syringe.

  
  

• On the basis of existing disposable syringes, a top rod is installed at the front end of the push rod. After injection is completed, the top rod pushes the needle off to prevent medical personnel from being stabbed.

  
  

• On the basis of existing disposable syringes, protective covers or sheaths, needle caps, sleeves, etc. for the needle are added near the needle. After the injection is completed, these accessories are used to cover the needle.