Syringe Mold/Mould

Confirm that the injection molding machine power is turned on.

Click the manual button of the injection molding machine to put it in manual mode.

Click the oil pump button of the injection molding machine to start the oil pressure system of the injection molding machine.

Transport the molds in place and confirm that they match the production accessories.

Use a sling to slowly lift the mold slightly above the injection molding machine, and move the sling bracket so that the mold is above the installation position. Be careful not to cause the mold to collide with the surveillance camera and robotic arm.

Slide the protective sleeve of the injection molding machine guide pillar to the appropriate position and slowly lower the mold. The operator should support the top of the mold to avoid it Intense shaking. The operator must control the mold and prohibit it from hitting the guide pillar. When the guide pillar is hit, it will cause concave and convex deformation, Damaging the sealing of the oil pressure system.

Lower the mold to the appropriate position, install the positioning flange and protective ring, adjust the mold and sling bracket to make the mold flange and protective ring fit with the injection hole of the injection molding machine.

Close the sliding doors on both sides of the injection molding machine, click the mold adjustment button of the injection molding machine, and enter the mold adjustment state.